Chamberlain TAC1 Manual do Utilizador

Installation and Programming Manual8970231564The Chamberlain Group845 Larch Ave.Elmhurst, IL 60126-1196www.liftmaster.comTAC1Telephone Entry System

10Ensure that the unit is grounded properly. The unit contains a number of static sensitive components that can be damaged by static discharge.To AVOI

11POWER12POWER1212 VacPower (included)110 Vac OutletCheck the Power LEDis illuminated.PLUG THE TRANSFORMER INTO THE OUTLETMOUNT THE UNITNOTE: Once pow

121. Place a telephone call from the resident’s telephone to verify it is operating properly, then hang up the phone.2. Press the “Call” key on the

13PROGRAMMING >> FROM THE TAC1 KEYPADGENERAL INSTRUCTIONCHANGE THE MASTER CODE1. Enter the Master Code: ? ? ? ?2. Enter the Program Code: 0 9

14The unit’s Master Code is for owner/administrator level commands. The User Codes allow users to activate and latch relays 1 and 2 and to transmit ra

15ENABLE TELCO MODEEnter the command tone: 0 7PROGRAMMING >> FROM THE TELEPHONEENABLE INTERCOM MODEEnter the command tone: 0 3ADJUST “PICK

16PROGRAM A PRE-INSTALLED LIFTMASTER RECEIVERERASE ALL CONTROL CODESPress and hold the learn button on the receiver until the indicator light turns of

17NOTE: Use the STAR Key “*” to cancel any input.NOTE: Keypad commands are to be entered in a single string to result in success (indicated by double

18TELEPHONE PROGRAMMINGPROGRAMMING NUMBER DESCRIPTION OF TASK FACTORY SETTING PROGRAMMING PROCEDURE**01 Enable Call Forwarding Disabled **01**02 Disab

19TAC1 MASTER CODEWrite down the Master Code and store in a secure location.

2TABLE OF CONTENTSSPECIFICATIONS 3Cable Requirements 3Dimensions 3Carton Inventory 3INSTALLATION 4-11Mount the Back Panel 4Description of the Proce

© 2011, The Chamberlain Group114A4075E All Rights ReservedThis document is protected by copyright and may not be copied or adapted without the prior

3CABLE REQUIREMENTSDIMENSIONSCARTON INVENTORYPower Supply: 12 Vac 20 VA or 16 Vdc 2.5AUnit (unlocked) (1)Key (1)12 Volt AC 20 VA Plug-In UL Listed Pow

41910651211 2131Autocall Input: Connector for accessory device to trigger home dialing.2Power Connector: 12 Volt AC power input.8Ground Wire: Wire

5Home PhoneRing(Not Provided)Telco Entrance BoxDemarcation PointTipAlarm System PositionNOTES:• The voltmeter measurement between the Tip and Ring s

6WIRING THE UNIT WITH A TELCO LINEWIRING THE UNIT WITHOUT A TELCO LINERing RingTipRingTip TipRingTipTelco Entrance BoxDemarcation PointRinger Equivale

7AUTO CALL12Loop SensorNO (Normally Open)Loop DetectorWIRING A GATE OPERATOR (NORMALLY OPEN)Primary Gate Operator(Strike Open Input)RELAY 1RELAY 2NO (

8Primary Gate Operator(Strike Open Input)COM (Common)NO (Normally Open)NOTE: For DC power install a 1N4001 diode or equivalent.NOTE: For AC power inst

9RELAY 1RELAY 2NOTE: For DC power install a 1N4001 diode or equivalent.AC or DC PowerCOM (Common)NO (Normally Open)NOTE: Do not use the unit’s power s