Chamberlain HE60R Manual do Utilizador

Installation and operating instructionsfor HomEntry garage door openerModel HE60RChamberlain Australia Pty LtdPhone toll free 1800 638 234Fax toll fre

Setting the LimitsThe Travel Limits regulate the points at which thedoor will stop when moving UP or DOWN. During theSetUp procedure, the motor will r

Setting the ForceThe force, as measured on the closing edge of the door,should not exceed 400N (40kg). If the closing force ismeasured to more than 40

10Install the Protector System™(Safety Beams)Install this accessory for all installations where theclosing force as measured on the bottom of thedoor

CARE OF YOUR OPENERWhen properly installed, your opener will provide high performance with minimal maintenance. The opener doesnot require additional

12Troubleshooting1. The opener doesn't operate from either theGREEN start button or the remote controls:• Does the opener have electric power? Pl

13OPERATION OF YOUR OPENERYour opener can be activated by any of the followingdevices:• The green start buttonHold the button down until door starts t

Liability – Australia onlyUnder no circumstances shall the Seller be liable forconsequential, incidental or special damages arising inconnection with

0

The Protector System must be used forall installations where the closing forceas measured on the bottom of the door isover 400N (40kgf).Excessive forc

Tools Required21. Ladder (or similar device to safely support door weight)2. Adjustable wrench for U-bolts already installed on the door3. 8mm socket,

3Door Requirements3Ensure that there is at least 45mm from the edge of the curtain to the edge of the bracket. If the roller doordrums are on the edge

Testing the doorDisable all locks and remove any ropes connected tothe garage door.Complete the following test to ensure your door is wellbalanced, an

5Preparing the Opener7For left hand side installationsthe wire jumper should be removed.Place the Opener in Manual Release mode.• Pull the release cor

6Installation steps8FOR RIGHT HAND INSTALLATIONS(REFER SECTION 7, page 5)• Ensure that the opener position jumper (wire connector) isinstalled (refer

Pinning the Door11Use two metal self tapping metal screws provided tohold the curtain to the door drum.Note: A ballooning may delay the safety respons